| LOAD ADC |
ADC plus over |
| − LOAD ADC |
ADC minus over |
| FULL |
Display plus over (greater than maximum display value) |
| − FULL |
Display minus over (less than minimum display value) |
| OVER FULL |
Input is exceeding maximum input range (5.2 mV/V) |
| − OVER FULL |
Input is less than minimum input range (−5.2 mV/V) |
| ZERO OVER |
Zero balancing range exceeds regulated values |
| ZERO ERROR |
Zero-adjusting failed within specified time |
| OUTPUT CAL OVER |
Sensor output exceeds calibration range |
| OUTPUT CAL SHORT |
Sensor output does not achieve calibration range |
| MINUS INPUT |
Sensor input is negative |
| TEDS READ ERROR |
A valid TEDS sensor is not connected |
| PARAMETER ERROR |
Irregular setting value exists |
| R.O.SET OVER |
Rated output exceeds the set range (greater than 5.0 mV/V) |
| R.O.SET SHORT |
Rated output below the set range (less than 0.3 mV/V) |
| ZEROLIMIT OVER |
Digital Zero Limit exceeded |
| ERROR |
An error has occurred |
| DA OVER |
DA output is outside output range |
| DA - OVER |
DA output is outside output range |
| SYSTEM ERROR |
A system error has occurred |
| INVALID OPERATION |
Operation is invalid |
| MEMORY FULL |
Memory for saving data is full. Delete data or enable overwriting using "System settings 2" |
